WHEELS AND TIRES
Wheels
Inspect all wheels for runout or damage. Check wheel bolts
and ensure they are tight. Do not over tighten the wheel bolts.
Wheel, Hub and Spindle Torque Table
Item Specification
Front wheel bolts 30Nm( 22ft. lbs)
Rear wheel bolts 30Nm( 22ft. lbs)
Front spindle nut 59Nm( 44ft. lbs)
Rear hub retaining nut 79Nm( 58ft. lbs)
Wheel Inspection
Inspect the front and rear wheel bolts for tightness. Re-torque
the wheel bolts periodically and check before each ride.
Wheel Removal - Front / Rear
1. Stop the engine, place the transmission in gear and lock the
parking brake.
2. Loosen the wheel bolts slightly.
3. Elevate the side of the vehicle by placing a suitable stand
under the footrest frame.
4. Remove the wheel bolts and remove the wheel.
Wheel Installation - Front / Rear
1. With the transmission in gear and the parking brake
locked, place the wheel in the correct position on the wheel
hub. Be sure the valve stem is toward the outside and
rotation arrows on the tire point toward forward rotation.
2. Install the wheel bolts and finger tighten them.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel bolts to 22 ft. lbs. (30 Nm)
To Next Page
Loading...
Need help?
General
