Fuses / Fuse Holder Location
A 7 Amp fuse protects the main electrical system on all
models. See illustrations for fuse locations.
Spark Plug Inspection
1. Remove spark plug high tension lead. Clean plug area so no
dirt and debris can fall into engine when plug is removed.
2. Remove spark plug.
3. Inspect electrodes for wear and carbon buildup. Look for a
sharp outer edge with no rounding or erosion of the electrodes.
4. Clean with electrical contact cleaner or a glass bead spark
plug cleaner only. CAUTION: A wire brush or coated
abrasive should not be used.
5. Measure gap with a wire gauge. Refer to specifications for
proper spark plug type and gap. Adjust gap if necessary by
bending the side electrode carefully.
6. If necessary, replace spark plug with proper type.
CAUTION: Severe engine damage may occur if the incorrect
spark plug is used.
7. Apply a small amount of anti-seize compound to the spark
plug threads.
8. Install spark plug and torque to 9 ft. lbs (12 Nm).
Recommended Spark Plug:
NGK BP7HS
Spark Plug Torque:
12 Nm ( 9 ft. lbs. )
2.18
To Next Page
Loading...
Need help?
General
