16
STORAGE
It may happen that, after receipt, the units do not need to be
installed immediately and are therefore stored in the warehouse.
In case of medium - long storage, it is recommended to apply
the following procedures:
• Check that there is no water in the plumbing systems.
• Do not remove the heat exchanger guards.
• Do not remove the protective plastic films.
• Check that the electrical panels are closed.
• Before using the equipment, store all the items supplied in a
dry and clean place so that they can be used in the future. It is
recommended to store the units in a dry and sheltered place
(especially for units intended for indoor environments).
Do not store the refrigeration system in confined spaces and
Provide adequate ventilation.
A
-
A
BB-
During lifting, the spacer bars must be longer than the unit to
prevent the unit from being damaged during handling due to
overly tight ropes.
When transporting the unit by forklift, use symmetrical positions
(A-A or B-B) whether lifting the machine through the holes on the
base or taking it from under the pallet. Alternatively, the unit can
be lifted off the base of the wooden pallet.
LIFT
Units are delivered on a pallet; for lifting use suitable belts and
to ensure that the structure is not damaged, place protections
between the belts (or ropes, chains) and the carpentry.
If you want to lift with the forklift it is recommended to open the
forks as much as possible to make handling safe:
• Follow all safety rules and regulations.
• Wear protective goggles and work gloves.
• During lifting, the degree of inclination must not exceed 15
degrees.
• Pay close attention to heavy and bulky equipment during
lifting and handling operations, and when resting on the
ground.
• All panels must be firmly fixed before moving the unit.
• Before lifting, check the specific weight on the technical plate.
• Use all, and only the lifting points, if indicated.
• Use standard ropes of equal length.
• Handle the unit carefully and without sudden movements.
• Do not stand under the unit during lifting.
• It is imperative to always keep the machine in a vertical
position.
Attention: Units cannot be stacked.
To Next Page
Loading...
