Why Agilent Technologies Water Pump displays Pump Configuration error?
The 'Pump Configuration' error on the Agilent Technologies Water Pump indicates that the active-inlet valve and pump encoder of channel B are disconnected. Reconnect them to resolve this issue.
What to do if Agilent Technologies Water Pump displays Encoder Missing error?
If the Agilent Technologies Water Pump displays an 'Encoder Missing' error, ensure the encoder cable is not damaged or dirty and is securely connected to the CSM board. If the problem persists, the pump drive assembly may be defective and needs to be replaced.
What to do if Agilent Technologies Water Pump displays Inlet-Valve Missing error?
If the Agilent Technologies Water Pump displays an 'Inlet-Valve Missing' error, first ensure the pins of the active inlet valve connector are not damaged and that the connector is securely seated. Also, check the connection cable (front panel to CSPM board) to ensure it is correctly seated; if defective, replace it. If the issue persists, the active inlet valve itself may be defective and need replacement.
What to do if Agilent Technologies Water Pump displays Electro-Magnetic-Proportional-Valve (EMPV) Missing?
If the Agilent Technologies Water Pump displays 'Electro-Magnetic-Proportional-Valve (EMPV) Missing', ensure the connection cable is seated correctly. If the problem persists, the solenoid of the EMPV may be defective and should be replaced.
What to do if Agilent Technologies Water Pump displays Flow sensor missing?
If the Agilent Technologies Water Pump displays a 'Flow sensor missing' error, ensure the sensor is seated correctly. If the error persists, the flow sensor may be defective and should be replaced.
What to do if Agilent Technologies Water Pump displays Leak Sensor Missing?
If the Agilent Technologies Water Pump displays a 'Leak Sensor Missing' error, ensure the connection cable is seated correctly. If the problem persists, the leak sensor may be defective and should be replaced.
General| Brand | Agilent Technologies |
|---|---|
| Model | 1100 Series |
| Category | Laboratory Equipment |
| Language | English |
Details on environmental conditions, power considerations, and power cords for detector operation.
Details on detection type, light source, wavelength range, noise, drift, and flow cell specifications.
Step-by-step instructions for physically installing the detector and connecting cables.
Procedures for connecting the flow cell capillaries and tubing to the detector.
Steps to note the MAC address and connect the instrument's LAN interface.
Details on IP address, Subnet Mask, and Default Gateway configuration methods.
Guidance on link speed/duplex settings and automatic configuration using Bootp.
Procedures for manual configuration using Telnet or a Handheld Controller.
Steps to configure the PC and Agilent ChemStation for LAN communication.
Steps for running samples, verifying results, and obtaining chromatograms.
Details on control, configuration, online spectra, analog outputs, spectrum, peakwidth, and slit settings.
Introduction to optimizing detector parameters for signal and spectral data.
Detailed explanation of the power supply and detector status indicators (green, yellow, red).
Essential safety warnings and precautions during maintenance and handling.
Step-by-step guide for replacing the deuterium or tungsten lamp.
Procedure for replacing the standard, semi-micro, or high-pressure flow cell.
Description of tests including intensity, wavelength calibration, and slit tests.
Comprehensive safety precautions for instrument operation, service, and repair.
To Next Page
