Agilent Technologies 6850 Series II User Manual

Messages
Fault messages
Released: March 2004 6850 Series II GC User Information page 98 of 256
FAULT 265 Inlet invalid PID
FAULT 267 Detector invalid PID
FAULT 269 Pneu aux invalid PID
Possible cause: Defective flow module.
The GC main board has determined that the inlet/detector/aux flow module
calibration setpoints are no longer valid. The module is unusable.
FAULT 270 Inlet bad checksum
FAULT 272 Detector bad checksum
FAULT 274 Pneu aux bad checksum
Possible cause: Defective flow module
The inlet/detector/aux flow module’s calibration setpoints are out of range and
are not valid.
FAULT 275 Inlet bad fact cal
FAULT 277 Det bad factory cal
FAULT 279 Pneu aux factory cal
Possible cause: Defective flow module
The inlet/detector/aux flow module’s calibration is invalid.
FAULT 280 Inlet I/O failure
FAULT 282 Det I/O failure
FAULT 284 Pneu aux I/O failure
Possible cause: Defective flow module.
The inlet/detector/aux flow module is malfunctioning. The GC main board
could not read/write to the module EEPROM.
FAULT 289 Oven fan motor
Possible causes: Oven fan motor not connected/missing
Oven fan motor defective
Defective main board
The controller for the primary oven fan motor detected a fault, and the oven is
shut down for safety.
FAULT 290 Zones not updating
Possible causes: Corrupted firmware
Defective main board
The program that controls one or more of the thermal zones has stopped, and
the zones may be uncontrolled. To prevent a thermal runaway, all thermal
zones are turned off.
Turn the GC off, then on. If the fault remains, update the GC firmware or
replace the main board.

Agilent Technologies 6850 Series II Specifications

General

Brand	Agilent Technologies
Model	6850 Series II
Category	Laboratory Equipment
Language	English