Introduction 1
Safety and Regulatory Certifications
Operation Manual 21
Refer servicing to qualified service personnel. Substituting
parts or performing any unauthorized modification to the
instrument may result in a safety hazard.
Symbols
Warnings in the manual or on the instrument must be observed
during all phases of operation, service, and repair of this
instrument. Failure to comply with these precautions violates
safety standards of design and the intended use of the
instrument. Agilent Technologies assumes no liability for the
customer’s failure to comply with these requirements.
See accompanying instructions for more information.
Indicates a hot surface.
Indicates hazardous voltages.
Indicates earth (ground) terminal.
Indicates potential explosion hazard.
Indicates radioactivity hazard.
Indicates electrostatic discharge hazard.
Indicates that you must not discard this electrical/electronic
product in domestic household waste.
To Next Page
Loading...
Need help?
General
