Agilent 8453 Dissolution Testing System Installing and Operating Manual 39
Setting Up 2
Installing a Valve-based Sampling System
Selecting Voltage
This safety symbol next to the voltage selector on the rear panel of the
valve-pump controller (see Figure 10) indicates you should refer to the
following information.
Figure 10 Rear View of Valve-Pump Controller
Safety symbol
Voltage selector
Line power socket
Serial number
(on base)
Check the line-voltage selector is set to the correct line voltage for operation from
your line-power supply, see Figure 10 and Tab le 11 for details.
Tab le 11 Voltage Selection
Power Supply Select
100–120 V AC 115 V AC
220–240 V AC 230 V AC
To Next Page
Loading...
