6 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
For reference information, see: • Chapter 21, “Reference,” starting on page 315
When using licensed serial bus
triggering and decode features, see:
• Chapter 22, “CAN/LIN Triggering and Serial Decode,”
starting on page 335
• Chapter 23, “FlexRay Triggering and Serial Decode,”
starting on page 351
• Chapter 24, “I2C/SPI Triggering and Serial Decode,”
starting on page 361
• Chapter 25, “I2S Triggering and Serial Decode,”
starting on page 381
• Chapter 26, “MIL-STD-1553/ARINC 429 Triggering and
Serial Decode,” starting on page 391
• Chapter 27, “UART/RS232 Triggering and Serial
Decode,” starting on page 407
Abbreviated instructions for pressing a series of keys and softkeys
Instructions for pressing a series of keys are written in an abbreviated manner. Instructions
for pressing [Key1], then pressing Softkey2, then pressing Softkey3 are abbreviated as
follows:
Press [Key1]> Softkey2 > Softkey3.
The keys may be a front panel [Key] or a Softkey. Softkeys are the six keys located directly
below the oscilloscope display.
To Next Page
Loading...
Need help?
General
