Agilent 1290 Infinity II Flexible Pump User Manual 199
LAN Configuration
11
Dynamic Host Configuration Protocol (DHCP)
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. Agilent ChemStation, Lab Advisor,
Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note
in section “General Information (DHCP)” on page 197).
Tabl e 14 LC Modules inclusive 1120/1220 (configuration switch at rear of the instru-
ment)
SW 6 SW 7 SW 8 Initialization Mode
ON OFF OFF DHCP
To Next Page
Loading...
Need help?
General
