Agilent 1290 Infinity II Flexible Pump User Manual 207
LAN Configuration
11
Automatic configuration with Bootp
4 The Error means the MAC address has not been assigned an IP address
and the Tab File does not have this entry. The MAC address is saved to
the Tab File when an IP address is assigned.
5 Close the log file before turning on another instrument.
6 Uncheck the Do you want to log BootP requests? box after configuring
instruments to avoid having the logfile use up excessive disk space.
Adding each instrument to the network using BootP
1 Follow Start > All Programs > Agilent BootP Service and select Edit BootP
Settings. The BootP Settings screen appears.
2 Uncheck the Do you want to log BootP requests? once all instruments have
been added.
The Do you want to log BootP requests? box must be unchecked when you
have finished configuring instruments; otherwise, the log file will
quickly fill up disk space.
3 Click Edit BootP Addresses... The Edit BootP Addresses screen appears.
4 Click Add... The Add BootP Entry screen appears.
Figure 34 Enable BootP logging
To Next Page
Loading...
Need help?
General
