210 Agilent 1290 Infinity II Flexible Pump User Manual
11 LAN Configuration
Automatic configuration with Bootp
3 Press Edit BootP Addresses… to edit the Tab File.
Figure 36 Edit BootP Adresses screen
4 In the Edit BootP Addresses... screen press Add... to create a new entry or
select an existing line from the table and press Modify... or Delete to
change the IP address, comment, subnet mask, for example, in the Tab
File.
If you change the IP address, it will be necessary to power cycle the
instrument for the changes to take effect.
5 Leave Edit BootP Addresses... by pressing Close.
6 Exit BootP Settings by pressing OK.
Restarting the Agilent BootP Service
1 In the Windows control panel, select Administrative Tools > Services. The
Services screen appears, see Figure 35 on page 209.
2 Right- click Agilent BootP Service and select Start.
3 Close the Services and Administrative Tools screens.