Revision H, 11/10 VK 7025 Dissolution Apparatus Page 41
P/N 70-9033 Operator’s Manual Setup
Varian, Inc.
Setting Up the User List
For initial set up of user identifications and passwords, the preprogrammed user
identification is 9 and the preprogrammed password is 9. It is recommended that you
immediately change the user identification and password for Administrative control of the
VK 7025 Dissolution Apparatus once your unit is installed.
To set up the user list, complete the following steps:
Step 1. Ensure the dissolution apparatus is turned on.
Step 2. If directed, press DRIVE UP to initialize the dissolution apparatus. The
drive unit moves to the home position and the Login screen displays.
Step 3. Enter the user identification (Login ID) and press ENTER.
Step 4. Enter the password and press ENTER. The System Setup Menu 1
screen displays.
Step 5. Select ADMINISTRATION. The Administration screen displays.
Step 6. Select ADD USER. The Enter User ID and Password screen displays.
Step 7. Enter the new user identification and press ENTER.
Step 8. Enter the new user password and press ENTER.
Step 9. Confirm the new password and press ENTER.
Note
To display a letter, hold down the number key until the
appropriate letter displays, then release the key. For example, to
display the letter C, press and hold 2. As you hold the number
key, the 2 displays and is replaced by an A, then a B and finally a
C. If you continue to hold the 2, these characters continue to
scroll until you release the number key.
To Next Page
Loading...
Need help?
General
