205
Settings and Adjustments
Station programming
4
■ Re-Transfer Destination
Delay Transfer
An incoming call can be automatically transferred if it is received during delay transfer and not answered over a
certain period of time (delay time).
■ Delay Transfer
Important
• Do not configure multiple VoIP phones as transfer destinations. If multiple VoIP phones are configured, calls will be transferred
to only one VoIP phone.
Entry Description Settings Default values
Re-Transfer Destination Configure the transfer destination station
(number) when performing absent re-transfer
for a transferred call. Only a single station can
be configured as the transfer destination.
However, if the station making the outgoing call
is IX-MV, IX-DA(-*), or IX-BA, the call will be
received without re-transferring. IXW-MA
cannot be configured as a transfer destination.
3-32 digits -
Important
• When an incoming call is received from a VoIP Phone, the call will be received without transferring even when transfer is set.
To transfer the call, configure transferring on the IP-PBX.
Entry Description Settings Default values
Delay Transfer Select Enable / Disable for Delay Transfer. To
enable "Delay Transfer", set
“Transfer
Destination List (→page 206)”.
• Disable: Delay transfer
disabled
• Enable: Delay transfer
enabled
Disable
To Next Page
Loading...
