224
Settings and Adjustments
Station programming
4
■ Monitor Timeout [sec]
*1 Indicates a required field. Use the default values, unless a change is necessary.
■ Scan Monitor
Perform monitoring by automatically switching between several stations and network cameras at set intervals.
■ Dwell Time
Master Station Display
Entry Description Settings Default values
Monitor Timeout [sec]
*1
Set the monitoring timer by station. Scan
Monitor must be end manually.
• Infinite
• 10-600 seconds:
Configure between 10
and 600 sec (by 1 sec).
60sec
Entry Description Settings Default values
Station / Network Camera
List
Configure the station and network camera to
perform scan monitoring. Scan monitoring will
be performed in order of series number. A
combined total of 1000 stations and network
cameras can be configured. Multiple network
cameras can also be set to a single station.
Select from stations and
network cameras
registered in "Address
Book." This cannot be
selected for IX-MV7-*,
IXW-MA, IX-MV, or a VoIP
phone.
-
Entry Description Settings Default values
Dwell Time Set the dwell time to change destination for
scan monitor.
• 5 sec
• 10 sec
• 30 sec
5 sec
Entry Description Settings Default values
Brightness Set the Brightness of Master station display. 1 - 10 6
Primary Video Source Select the primary video source when showing
2 video stream simultaneously.
• IX Station
• Network Camera
IX Station
Aspect Ratio Select the video aspect for primary video
source.
• 16:9
• 4:3
16:9
Standby LED State Select ON / OFF for standby status LED. • ON
• OFF
ON
Keypad Select ON / OFF for whether to display the
keypad used for door release and playing
location messages.
•ON
• OFF
ON
To Next Page
Loading...
Need help?
General
