Aiwa NSX-430 - DUBBING THE WHOLE TAPE

3
50
SYNCHRO DUBBING
HIGH/NORMAL
RECORDING
DUBBING THE WHOLE TAPE |
When an original tape is dubbed onto another tape rated at the
same recording time, the back side of the recording tape may not
be an exact duplicate of the back side of the original tape.
This is because there are differences in actual recording times
between tapes, since each tape has a bit more time than indicated
on the label. This time varies with each brand.
This unit’s STSD function allows you to make exact copies of both
sides of the original tape.
—_
Press the TAPE/DECK1/2 button.
If a tape is inserted
When pressing the TAPE/DECK1/2 button with the power off,
play begins by the direct play function. Press the Il button to
stop playback.
2 Insert the original tape into deck 1 and the tape to
be recorded on into deck 2.
Press the EJECT & marks to open the cassette holders.
insert the tapes with the sides to be played back or recorded first
facing you and the exposed sides down.
3 Press the SYNCHRO DUBBING button once or
twice to select the dubbing speed.
To dub at normal speed:
Press the button once so that N-DUB is displayed.
To dub at high speed:
Press the button twice so that H-DUB is displayed.
N-DUB or H-DUB is displayed, the tapes are rewound to the
beginning of their front sides, and then recording starts. After
recording of the front side ends, the back sides of both tapes will
start at the same time as soon as the longer tape has been
reversed (STSD function).
NOTE)
During rewinding to the beginning of the front side, the dubbing
speed can be changed by pressing the SYNCHRO DUBBING
button.
To stop dubbing in the middle
Press the If button.
NOTE}
* Regardless of whether the OO NR indicator is displayed or not, the
Doiby NR system does not affect the recording.
¢ Recording is inhibited if the erasure prevention tab oneither side
of the tape is broken off.
¢ If the leader segment of the dubbing tape is longer than that of the
original tape, recording on the back side may stop midway
through the recording. In this case, dub each side manually
following the procedure in “RECORDING FROM TAPE TO TAPE
MANUALLY” (See page 48).