Aiwa NSX-430 - PRECAUTIONS; On AC voltage; On placement; On safety

PRECAUTIONS
Follow the advice below for safe and correct operation.
On AC voltage
Before use, check that the rated voltage of your system matches
your local voltage.
On placement
* Do not use the system in places which are extremely hot, cold,
dusty or humid.
¢ Place the system on a flat, even surface.
* Be careful not to obstruct the ventilation holes on the exterior of
the unit, as increased internal temperature may affect the electric
parts. In particular, do not place the system in an airtight rack.
On safety
¢ When connecting and disconnecting the AC cord, grip the plug
and not the cord itself. Pulling the cord may damage it and thus
be hazardous.
¢ When you are not going to use the system fora long period of time,
disconnect the AC cord. If the cord is plugged in, asmall amount
of current keeps on flowing to the system even if the power switch
is not ON.
e lf the AC cord is broken or damaged, or if the wires are
exposed, contact your dealer or an Aiwa service centre and
have it replaced or repaired immediately.
On condensation
When the room is heated, you sometimes see water drops on your
windows; this is called condensation.
This can occur inside the CD player unit when:
¢ it is moved from a cold spot to a warm spot.
¢ itis used ina room where the heating system has just been turned
on.
¢ it is used in a place with a lot of moisture.
¢ itis used where it has direct contact with cool air, suchas near an
air-conditioner.
Whenithas condensation inside, the unit may not function normally.
Let it stand for 1 to 2 hours before turning the power on; or, gradually
heat the room and dry the unit before use.
Should any trouble occur, disconnect the AC cord and contact
a qualified service representative.