R28 Door Phone Administrator Guide
Parameter Set-up:
•
Mode: select Power on, Repeatedly, Power On + Repeatedly, Hourly Repeat as your
Autop schedule.
•
Select Power on, if you want the device to perform Autop every time it boots
up.
•
Select Repeatedly, if you want the device to perform Autop according to the
schedule you set up.
•
Select Power On + Repeatedly, if you want to combine Power On mode and
Repeatedly mode that will enable the device to perform Autop every time it
boots up or according to the schedule you set up.
•
Select Hourly Repeat, if you want the device to perform Autop every hour.
21.3
PNP Configuration
Plug and Play (PNP) is a combination of hardware and software support that enables a
computer system to recognize and adapt to hardware configuration changes with little or
no intervention by a user. To do this configuration on web Upgrade > Advanced > PNP
Option interface.
To Next Page
Loading...
