R28 Door Phone Administrator Guide
•
Time (H): enter the time span for the LED lighting to be valid. E.g. If the time span is
from 18-22 it means LED light will stay on during the time span from 6:00 pm to
22:00 pm during a day.
•
Keypad LED Enabled: click to enable or disable the keypad LED lighting.
7.4
LED Settings on Screen
You can enable or disable the LED lighting of the screen as needed on the web interface.
Meanwhile, if you prefer not to have the LED light on the screen stay on, you can also set
the timing for the exact time span during which the LED light can be enabled in order to
reduce the electrical power consumption, etc. To do this configuration, go to Intercom >
LED Setting > LED Control.
Parameter Set-up:
•
Wake Mode: there are two modes - Auto and Manual for waking up the device when
idle. If you select Auto mode then the screen will be awakened when someone
approaches, and the IR sensor will be triggered. And if Manual mode is selected, then
you have to touch the keypad.
•
Screen LED Enabled: click to enable or disable the screen LEDlighting.
•
Time(H): enter the time span for the LED lighting to be valid. For example, if the time
span is from 18-22 it means LED light will stay on during the time span from 6:00 pm
to 22:00 pm during a day.
7.5
LCD Screen Display
You can customize the LCD display. You can do this configuration on the web Intercom >
Advanced interface.
To Next Page
Loading...
Need help?
General
