R28 Door Phone Administrator Guide
7.2
LED Setting on Card Reader Area
You can enable or disable the LED lighting on the card reader area as needed on the web
interface. Meanwhile, if you do not want to have the LED light on the card reader area stay
on, you can also set the timing for the exact time span during which the LED light can be
disabled in order to reduce the electrical power consumption. To do this configuration, go
to Intercom > LED Setting > LED Control.
Parameter Set-up:
•
Card LED Enabled: if enabled, the LED light will stay on during the time interval (Start
Time (H)). If disabled, the LED light will stay off and will turn on only when you swipe
cards or press the keypad, and the time interval will become non-editable.
•
Time (H): set the time interval for the light to stay on. enter the time interval for the
LED light to be turned on, e.g., if the time interval is set from 8-0 (Start time- End
time) it means the LED light will stay on during the time span from 8:00 am to
12:00 pm during one day (24 hours). This setting can not be set up when you disable
the LED light.
7.3
LED Settings on Keypad
You can enable or disable the LED lighting of the keypad as needed on the web interface.
Meanwhile, if you prefer not to have the LED light of the keypad stay on, you can also set
the timing for the exact time span during which the LED light can be enabled in order to
reduce the electrical power consumption, etc. To do this configuration, go to Intercom >
LED Setting > LED Control interface.
Parameter Set-up:
To Next Page
Loading...
Need help?
General
