R28 Door Phone Administrator Guide
22 Integration with Third Party Device
22.1
Integration via Wiegand
If you want to integrate the Akuvox door phone with the third-party devices via Wiegand,
you can configure the Wiegand on the web Intercom > Wiegandinterface.
Parameter Set-up:
•
Wiegand Display Mode: select Wiegand Card code format among 8H10D; 6H3D5D;
6H8D; 8HN; 8HR; RAW.
•
Wiegand Card Reader Mode: set the Wiegand data transmission format among three
options: Wiegand 26, Wiegand 34, Wiegand 58. The transmission format should be
identical between the door phone and the device to beintegrated.
•
Wiegand Transfer Mode: select Input, Output, Convert to Card
No.OutputWiegand. If the door phone is used as a receiver, then set it as Input for
the door phone. Select Output if you want Wiegand output to be converted to a card
number before sending it from the door phone to a receiver.
•
Wiegand Input Data Order: set the Wiegand input data sequence between Normal
and Reversed. If you select Reversed then the input card number will be reversed and
vice versa.