R28 Door Phone Administrator Guide
•
Suspicious Moving Object Detection: select Disable to disable the motion detection.
Select IR detection to enable the IR sensor-based motion detection for suspicious
moving objects. And select Video detection to enable the video-based motion
detection during the monitoring of the suspicious movingobject.
•
Detection Accuracy: set the detection accuracy for the detection sensitivity. The
smaller the value is, the greater the sensitivity is. The default detection accuracy
value is 3.
•
TimeInterval: the absolute triggering interval is 3 seconds. If you select a number
greater than 3 seconds, then it requires a second triggering interval to trigger the
alarm. For example, if you select 3 seconds, then the alarm will be triggered when a
moving object is detected one time from 0 to 3 seconds (triggered any time from 0 to
3 seconds). However, for example, if you select 5 seconds (greater than 3 ), then the
alarm will not be triggered until a moving object is detected for the second time from
3 to 5 seconds (triggered any time from 3 to 5 seconds). The default interval is 10
seconds.
•
The Width of Detected Area/The Height of Detected Area: The full size of the
detection area is calculated by percentage (100%)from left to right. Pick the
horizontal detection range anywhere from 0% to 100%, and pick the vertical detection
range anywhere from 0% to 100%. After that, you will be able to get the exact
detection area you want.
•
Day/time: set the days and time for the motion detection.
15.1.3
Security Notification Setting
15.1.3.1
Email Notification Setting
If you want to receive the security notification via email, you can configure the Email
notification on the web Intercom > Action > Email Notification interface properly. The
email notification will show as the captures.
To Next Page
Loading...
Need help?
General
