R28 Door Phone Administrator Guide
Parameter Set-up:
•
Service: disable or enable the remote debug server.
•
Connect Status: displays the remote debug server connectionstatus.
•
IP: enter the remote debug server IP address.
•
Port: enter the remote debug server port.
18.3
PCAP
PCAP is used to capture the data package going in and out of the devices for debugging
and troubleshooting purposes. You can set up the PCAP on the device web Upgrade >
Advanced > PCAP interface properly before using it.
Parameter Set-up:
•
Specific Port: select the specific ports from 1-65535 so that only the data packet
from the specific port can be captured. You can leave the field blank by default.
To Next Page
Loading...
Need help?
General
