Configuration and Image Loading
Page 126 7210 SAS M, T, X, R6 Basic System Configuration Guide
search for the files that contains the runtime image. The locations can be local or remote. The first
location searched is the primary image location. If not found, the secondary image location is
searched, and lastly, the tertiary image location is searched. Figure 5, Figure 6, and Figure 7
describe the bootstrap process.
NOTE: The description for configuration and Image loading that appears in the section and the
following ones applies to all the 7210 SAS platforms with the following exceptions:
− On 7210 SAS-R6, only manual mode using OOB port/ethernet management port is
supported. Obtaining IP and other parameters using DHCP with the OOB port is not
supported. Auto-init is not supported on 7210 SAS-R6.
− On 7210 SAS-M/X/T, both manual mode and auto-init mode is supported.
The following diagrams and paragraphs provide details of how the 7210 platform boot up on
power ON, how it obtains the Timos image file, the BOF file, and the config file and loads the
image and configuration file to bring up the platform.
To Next Page
Loading...
