Boot Option Files
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 135
eth-mgmt-speed 100
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode network
acl-mode IPv6-None
use-expansion-card-type m4-ds1-ces
no console-disabled
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
Incorrect password
Password:
Incorrect password
Password:
Incorrect password
Authentication failed, Do you want to reset password?(yes/no)
*******************************************************************
On reset,the node's flash contents will be set to factory defaults.
All files on the flash will be removed. If present, files
cf1:/boot.tim and cf1:/both.tim are not removed.
Please ensure that you have a backup of the required
files before you proceed.
*******************************************************************
'yes' or 'no' ?
'yes' or 'no' ? yes
********************************************
*** Chassis must not be powered off nor ***
*** cards removed while password reset ***
*** is in progress ***
********************************************
Password reset complete. Restarting...
At this point the password has been reset and the node is rebooted to boot up with factory default
settings.
Resetting...OK
ø
To Next Page
Loading...
