Boot Option Files
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 149
a USB flash drive, or on the network.
Here are some examples
cf1:/timos1.0R1
uf1:/timos1.0R1
ftp://user:passwd@192.168.1.150/./timos1.0R1
ftp://user:passwd@[3FFE::1]/./timos1.0R1
tftp://192.168.1.150/./timos1.0R1
tftp://[3FFE::1]/./timos1.0R1
The existing Image URL is 'ftp://*:*@135.250.26.204/tmp/sasr/b/'
Press ENTER to keep it.
Software Image URL:
Using: 'ftp://*:*@135.250.26.204/tmp/sasr/b/'
Configuration File Location
---------------------------
You must enter the location of configuration
file to be used by TiMOS. The file can be on
a Compact Flash device, a USB flash drive, or
on the network.
Here are some examples
uf1:/config.cfg
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
ftp://user:passwd@[3FFE::1]/./config.cfg
tftp://192.168.1.150/./config.cfg
tftp://[3FFE::1]/./config.cfg
The existing Config URL is 'uf1:\SASR2553.cfg'
Press ENTER to keep it, or the word 'none' for no Config URL.
Config File URL:
Using: 'uf1:\SASR2553.cfg'
Network Configuration
---------------------
You specified a network location for either the
software or the configuration file. You need to
assign an IP(v6) address for this system.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.1.169/24
Existing eth-mgmt port settings are:
eth-mgmt-port
eth-mgmt-address 10.135.25.53/24 active
eth-mgmt-address 10.135.25.54/24 standby
eth-mgmt-address 0 active
eth-mgmt-address 0 standby
eth-mgmt-route 2.2.2.0/24 next-hop 10.135.25.1
eth-mgmt-route 3.3.3.0/24 next-hop 10.135.25.1
eth-mgmt-route 10.135.0.0/16 next-hop 10.135.25.1
eth-mgmt-route 135.0.0.0/8 next-hop 10.135.25.1
To Next Page
Loading...
