Alcatel-Lucent 7210 SAS M - Page 272

Common Configuration Tasks
Page 272 7210 SAS M, T, X, R6 Basic System Configuration Guide
Server-address
The server-address command configures an SNTP server for SNTP unicast client mode.
CLI Syntax: config>system>time>sntp#
config>system>time>sntp# server-address ip-address version version-
number] [normal|preferred] [interval seconds]
Example : config>system>time>sntp#
config>system>time# server-address 10.10.0.94 version
1 preferred interval 100
The following example shows SNTP enabled with the server-address command configured.
A:ALA-12>config>system>time# info
----------------------------------------------
sntp
server-address 10.10.0.94 version 1 preferred interval 100
no shutdown
exit
dst-zone PT start-date 2006/04/04 12:00 end-date 2006/10/25 12:00
zone GMT
----------------------------------------------
A:ALA-12>config>system>time#