Alcatel-Lucent 7210 SAS M Configuration Guide

System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 347
memory-use-alarm
Syntax memory-use-alarm rising-threshold threshold [falling-threshold threshold] interval
seconds [rmon-event-type] [startup-alarm alarm-type]
no memory-use-alarm
Context config>system>thresholds
Description The memory thresholds are based on monitoring the TIMETRA-SYSTEM-MIB sgiMemoryUsed
object. This object contains the amount of memory currently used by the system. The severity level is
Alarm. The absolute sample type method is used.
The no form of this command removes the configured memory threshold warning.
Parameters rising-threshold threshold — Specifies a threshold for the sampled statistic. When the current
sampled value is greater than or equal to this threshold, and the value at the last sampling interval
was less than this threshold, a single threshold crossing event will be generated. A single
threshold crossing event will also be generated if the first sample taken is greater than or equal to
this threshold and the associated startup-alarm is equal to rising or either.
After a rising threshold crossing event is generated, another such event will not be generated
until the sampled value falls below this threshold and reaches less than or equal the falling-
threshold value.
Default 0
Values -2147483648 — 2147483647
falling-threshold threshold — Specifies a threshold for the sampled statistic. When the current
sampled value is less than or equal to this threshold, and the value at the last sampling interval
was greater than this threshold, a single threshold crossing event will be generated. A single
threshold crossing event will also be generated if the first sample taken is less than or equal to
this threshold and the associated startup-alarm is equal to falling or either.
After a rising threshold crossing event is generated, another such event will not be generated
until the sampled value raises above this threshold and reaches greater than or equal the rising-
threshold threshold value.
Default 0
Values -2147483648 — 2147483647
interval seconds — Specifies the polling period over which the data is sampled and compared with
the rising and falling thresholds.
Values 1 — 2147483647
rmon-event-type — Specifies the type of notification action to be taken when this event occurs.
Values log — In the case of log, an entry is made in the RMON-MIB log table for each
event occurrence. This does not create an OS logger entry. The RMON-MIB log
table entries can be viewed using the CLI command.
trap — In the case of trap, a TiMOS logger event is generated. The TiMOS logger
utility then distributes the notification of this event to its configured log

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English