Alcatel-Lucent 7210 SAS M - Page 384

System Synchronization Commands
Page 384 7210 SAS M, T, X, R6 Basic System Configuration
Guide
System Synchronization Commands
sync-if-timing
Syntax sync-if-timing
Context config>system
Description This command creates or edits the context to create or modify timing reference parameters.
Default Disabled (The ref-order must be specified in order for this command to be enabled.)
abort
Syntax abort
Context config>system>sync-if-timing
Description This command is required to discard changes that have been made to the synchronous interface
timing configuration during a session.
Default No default
begin
Syntax begin
Context config>system>sync-if-timing
Description This command is required in order to enter the mode to create or edit the system synchronous
interface timing configuration.
Default No default
commit
Syntax commit
Context config>system>sync-if-timing
Description This command saves changes made to the system synchronous interface timing configuration.
Default No default
Values