Alcatel-Lucent 7210 SAS M Configuration Guide

CLI Usage
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 39
The range cannot cause a change in
contexts.
Commands should be formed in such a way that there is no context
change upon command completion. For example,
configure port 1/1/[1..10]
will attempt to change ten different contexts. When a range is specified
in the CLI, the commands are executed in a loop. On the first loop
execution, the command changes contexts, but the new context is no
longer valid for the second iteration of the range loop. A “Bad
Command” error is reported and the command aborts.
Command completion may cease to
work when entering a range.
After entering a range in a CLI command, command and key
completion, which normally occurs by pressing the <Tab> or spacebar,
may cease to work. If the command line entered is correct and
unambiguous, the command works properly; otherwise, an error is
returned.
Table 8: CLI Range Use Limitations (Continued)
Limitation Description

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English