Alcatel-Lucent 7210 SAS M - Page 394

System Administration Commands
Page 394 7210 SAS M, T, X, R6 Basic System Configuration
Guide
A:ALA-1>admin# save ftp://test:test@192.168.x.xx/./100.cfg
Saving configuration .........Completed.
By default, the running configuration is saved to the primary configuration file.
Parameters file-url — The file URL location to save the configuration file.
Default The primary configuration file location.
Values <file-url> : <local-url>|<remote-url> - [255 chars max]
local-url - [<cflash-id>/ | <usb-flash-id>][file-path]
remote-url - [{ftp://|tftp://}<login>:<pswd>@
<remote-locn>/][<file-path>]
remote-locn - [ <hostname> | <ipv4-address> |
"["<ipv6-address>"]" ]
ipv4-address a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface - 32 chars max, for link
local addresses
cflash-id - cf1:, cf2 (only on 7210 SAS-T)
usb-flash-id -uf1:
detail — Saves both default and non-default configuration parameters.
index — Forces a save of the persistent index file regardless of the persistent status in the BOF file.
The index option can also be used to avoid an additional boot required while changing your
system to use the persistence indices.
enable-tech
Syntax [no] enable-tech
Context admin
Description This command enables the shell and kernel commands.
NOTE: This command should only be used with authorized direction from the Alcatel-Lucent
Technical Assistance Center (TAC).
tech-support
Syntax tech-support file-url
Context admin
Description This command creates a system core dump.
NOTE: This command should only be used with authorized direction from the Alcatel-Lucent
Technical Assistance Center (TAC).