System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 401
The no form of the command removes the parameter from the configuration.
Default none
Parameters boot-env — Synchronizes all files required for the boot process (loader, BOF, images, and config).
config — Synchronizes only the primary, secondary, and tertiary configuration files.
display-config
Syntax display-config [detail | index]
Context admin
Description This command displays the system’s running configuration.
By default, only non-default settings are displayed.
Specifying the detail option displays all default and non-default configuration parameters.
Parameters detail — Displays default and non-default configuration parameters.
index — Displays only persistent-indices.
force-switchover
Syntax force-switchover [now]
Context admin>redundancy
Description
This command forces a switchover to the standby
CPM/CFM
card. The primary
CPM/CFM
reloads
its software image and becomes the secondary
CPM/CFM
.
Parameters now — Forces the switchover to the redundant
CPM/CFM
card immediately.
switchover-exec
Syntax switchover-exec file-url
no switchover-exec
Context config>system
Description This command specifies the location and name of the CLI script file executed following a redundancy
switchover from the previously active CPM/CFM card. A switchover can happen because of a fatal
failure or by manual action.
The CLI script file can contain commands for environment settings, debug (excluding mirroring
settings), and other commands not maintained by the configuration redundancy.
The following commands are not supported in the switchover-exec file: clear, configure, candidate,
oam, tools, oam, ping, traceroute, mstat, mtrace and mrinfo.
To Next Page
Loading...
Need help?
General
