System Resource-Profile Commands
Page 422 7210 SAS M, T, X, R6 Basic System Configuration
Guide
Examples
:
The following examples show the list of ports, range of ports, and a combination of list of ports and
range of ports that can be specified.
List of ports can be specified as:
– 1/1/1, 1/1/2, 1/2/1, 1/1/10 is allowed
– 1/1/10, 1/1/2, 1/1/9, 1/1/5 is allowed
Range of ports can be specified as:
– 1/1/2-1/1/5 is allowed
– 1/2/1-1/2/2 is allowed
– 1/1/10-1/1/2 is not allowed
– 1/1/1 – 1/2/2 is not allowed
A combination of list of ports and range of ports can be specified as:
– 1/1/5,1/1/6,1/1/10-1/1/15,1/1/25 is allowed
– 1/1/5,1/1/6,1/1/10-1/1/12,1/1/13-1/1/15 is allowed
– 1/1/5,1/1/6,1/1/10-1/1/12,1/2/1-1/2/2 is allowed
egress-internal-tcam
Syntax egress-internal-tcam
Context configure>system>resource-profile
Description This command provides the context to allocate egress internal TCAM resources.
acl-sap-egress
Syntax [no] acl-sap-egress
Context configure>system>resource-profile>egress-internal-tcam
Description This command allows the user to allocate maximum resources for use by egress filter policies using
any of the supported match criteria. This command limits the total amount of chunks allocated for use
by egress filter policies to the value specified by num-resources. In other words, the cumulative sum
of chunks allocated to different match criteria supported by filter policies cannot exceed the value
configured with num-resources.
With the no form of the command, software does not allocate any resources for use by egress filter
policies. If no resources are allocated for use, then the software fails all attempts to associate a service
entity (For example: SAP, IP interface) with a filter policy using any of the match criteria.
Parameters num-resources — Specifies the amount of resources that can be allocated for use by ACL policies.
To Next Page
Loading...
