System Resource-Profile Commands
Page 424 7210 SAS M, T, X, R6 Basic System Configuration
Guide
ipv6-128bit-match-enable
Syntax [no] ipv6-128bit-match-enable num-resources
Context configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Description This command allows the user to allocate maximum resources for use by egress filter policies using
ipv6 criteria with 128-bit IPv6 addresses.
The resources cannot be shared with any other egress filter policies that specify other match crtieria.
Please see the 7210 SAS Router Configuration guide for more information on resource allocation
details and fields available for use.
With the no form of the command, the software does not allocate any resources for use by egress filter
policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources are allocated for use, then the
software fails all attempts to associate a service entity (e.g. SAP, IP interface, etc.) with a filter policy
using this match criteria.
Default no ipv6-128bit-match-enable
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
Values [0|2]
Default 0
NOTE: A value of 1 cannot be used.
mac-ipv4-match-enable
Syntax [no] mac-ipv4-match-enable num-resources
Context configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Description This command allows the user to allocate maximum resources for use by egress filter policies using
IPv4 criteria or MAC criteria. The resources allocated are allocated on a first-cum-first-serve basis
among service entities (For example: SAP, IP interface, etc) using IPv4 and MAC criteria egress filter
policies.
The resources cannot be shared with any other egress filter policies that specify other match criteria.
Please see the 7210 SAS Router Configuration guide for more information on resource allocation
details and fields available for use.
With the no form of the command, the software does not allocate any resources for use by egress filter
policies using MAC or IPv4 criteria. If no resources are allocated for use, then the software fails all
attempts to associate a service entity (e.g. SAP, IP interface, etc.) with a filter policy using this match
criteria.
Default mac-ipv4-match-enable 2 (to maintain backward compatibility with earlier releases)
Parameters num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
Values [0|2]
Default 0
To Next Page
Loading...
