Alcatel-Lucent 7210 SAS M - Page 452

System Commands
Page 452 7210 SAS M, T, X, R6 Basic System Configuration Guide
schedule
Syntax schedule [schedule-name] [owner schedule-owner]
Context show>cron#
Description This command displays cron schedule parameters.
Parameters schedule-name — Displays information for the specified scheduler name.
owner schedule-owner — Displays information for the specified scheduler owner.
Output The following table describes the show cron schedule output fields.
A:sim1>show>cron schedule test
Label Description
Schedule name
Displays the schedule name.
Schedule owner
Displays the owner name of the action.
Description
Displays the schedule’s description.
Administrative
status
Enabled — The administrative status is enabled.
Disabled — Administratively disabled.
Operational sta-
tus
Enabled — The operational status is enabled.
Disabled — Operationally disabled.
Action
Displays the action name
Action owner
Displays the name of action owner.
Script
Displays the name of the script.
Script owner
Displays the name of the script.
Script owner
Displays the name of the of script owner.
Script source
location
Displays the location of scheduled script.
Script results
location
Displays the location where the script results have been sent.
Schedule type
Periodic — Displays a schedule which ran at a given interval.
Calendar — Displays a schedule which ran based on a calendar.
Oneshot — Displays a schedule which ran one time only.
Interval
Displays the interval between runs of an event.