System Commands
Page 494 7210 SAS M, T, X, R6 Basic System Configuration Guide
Context show
Description This command displays the time since the system started.
Output Uptime Output — The following table describes uptime output fields.
Sample Output
A:ALA-1# show uptime
System Up Time : 11 days, 18:32:02.22 (hr:min:sec)
A:ALA-1#
sync-if-timing
Syntax sync-if-timing
Context show>system
Description This command displays synchronous interface timing information.
Output System Timing Output — The following table describes sync-if-timing output fields.
Table 39: System Timing Output Fields
Label Description
System Up Time
Displays the length of time the system has been up in days,
hr:min:sec format.
Label Description
System Status CPM A
Indicates the system status of CPM A.
Reference Input Mode
Indicates the reference input mode.
Reference Order
Indicates the reference order.
Reference Input 1
Displays information about reference input 1
Admin Status
Indicates the Admin status of reference input 1.
down — Indicates the ref1 or ref2 configuration is administratively
shutdown.
up — Indicates the ref1 or ref2 configuration is administratively
enabled.
diag — Indicates the reference has been forced using the force-refer-
ence command.
Qualified For Use
Indicates if the reference input 1 is qualified for use
To Next Page
Loading...
