Configuration Rollback
Page 50 7210 SAS M, T, X, R6 Basic System Configuration Guide
• The following list captures some side effects and specific behaviors of a Rollback revert.
Some of these side effects are not related purely to configuration (that is, in the CLI config
branch) and may have interactions with tools commands, RADIUS, etc.
− SAA jobs that are running when a rollback revert is initiated, and need configuration
changes due to the rollback, will be stopped. If the SAA job is a continuous type then
it will be re-started as part of the rollback revert after the config changes have been
applied (just as if the operator had typed “no shutdown” for the continuous SAA job).
Non-continuous SAA jobs that were modified by the rollback would need to be
manually restarted if they need to be run again.
− If max-nbr-mac-addr is reduced as part of the revert and the number of mac
addresses in the forwarding database is greater than the max-nbr-mac-addr, then the
rollback is aborted (before any actions are taken) and an informative error message is
provided. The operator must take actions to remove the mac addresses, if they wish to
proceed with the rollback.
− If a force-switchover command (for example, tools perform service id 1 endpoint "x"
force-switchover spoke-sdp-fec 1) has been applied to a spoke-sdp-fec of a dynamic
multi-segment pseudo wire, and a rollback revert needs to change the admin state of
the spoke-sdp-fec (for example, to modify spoke-sdp-fec parameters that may be
To Next Page
Loading...
Need help?
General
