IP Router Command Reference
134 7705 SAR OS Router Configuration Guide
time-exceeded
Syntax time-exceeded [number seconds]
no time-exceeded
Context config>router>if>ipv6>icmp6
Description This command enables the generation of ICMPv6 time-exceeded messages and configures the rate that
the messages are issued by the IP interface.
The no form of the command disables the sending of ICMPv6 time-exceeded messages.
Default 100 10
Parameters number — the maximum number of time-exceeded messages to send, expressed as a decimal
integer, in the time frame specified by the seconds parameter
Values 10 to 1000
seconds — the time frame, in seconds, used to limit the number of time-exceeded messages that
can be issued, expressed as a decimal integer
Values 1 to 60
unreachables
Syntax unreachables [number seconds]
no unreachables
Context config>router>if>ipv6>icmp6
Description This command enables the generation of ICMPv6 host and network destination unreachable messages
on the router interface. The rate at which ICMP unreachables is issued can be controlled with the
optional number and seconds parameters by indicating the maximum number of destination
unreachable messages that can be issued on the interface for a given time interval.
The no form of the command disables the generation of ICMPv6 destination unreachables on the
router interface.
Default 100 10
Parameters number — the maximum number of destination unreachable messages to send, expressed as a
decimal integer, in the time frame specified by the seconds parameter
Values 10 to 1000
seconds — the time frame, in seconds, used to limit the number of destination unreachable
messages that can be issued, expressed as a decimal integer
Values 1 to 60
To Next Page
Loading...
