IP Router Configuration
7705 SAR OS Router Configuration Guide 133
packet-too-big
Syntax packet-too-big [number seconds]
no packet-too-big
Context config>router>if>ipv6>icmp6
Description This command enables the generation of ICMPv6 packet-too-big messages and configures the rate that
the messages are issued by the IP interface.
The no form of the command disables the sending of ICMPv6 packet-too-big messages.
Default 100 10
Parameters number — the maximum number of packet-too-big messages to send, expressed as a decimal
integer, in the time frame specified by the seconds parameter
Values 10 to 1000
seconds — the time frame, in seconds, used to limit the number of packet-too-big messages that
can be issued, expressed as a decimal integer
Values 1 to 60
param-problem
Syntax param-problem [number seconds]
no param-problem
Context config>router>if>ipv6>icmp6
Description This command enables the generation of ICMPv6 param-problem messages and configures the rate
that the messages are issued by the IP interface.
The no form of the command disables the sending of ICMPv6 param-problem messages.
Default 100 10
Parameters number — the maximum number of param-problem messages to send, expressed as a decimal
integer, in the time frame specified by the seconds parameter
Values 10 to 1000
seconds — the time frame, in seconds, used to limit the number of param-problem messages that
can be issued, expressed as a decimal integer
Values 1 to 60
To Next Page
Loading...
