Filter Policies
7705 SAR OS Router Configuration Guide 335
Filter Log Commands
log
Syntax log log-id [create]
no log log-id
Context config>filter
Description This command enables the context to create a filter log policy.
The no form of the command deletes the filter log ID. The log cannot be deleted if there are filter
entries configured to write to the log. All filter entry logging associations need to be removed before
the log can be deleted.
Default log 101
Special Cases Filter log 101 — filter log 101 is the default log and is automatically created by the system. Filter
log 101 is always a memory filter log and cannot be changed to a syslog filter log. The log
size defaults to 1000 entries. The number of entries and wrap-around behavior can be edited.
Parameters log-id — the filter log ID destination expressed as a decimal integer
Values 101 to 199
destination
Syntax destination memory num-entries
destination syslog syslog-id
no destination
Context config>filter>log
Description This command configures the destination for filter log entries for the specified filter log ID.
Filter logs can be sent to either memory or an existing syslog server. If the filter log destination is
memory, the maximum number of entries in the log must be specified.
The no form of the command deletes the filter log association.
Default no destination
To Next Page
Loading...
