Filter Command Reference
336 7705 SAR OS Router Configuration Guide
Parameters num-entries — specifies that the destination of the filter log ID is a memory log. The num-entries
value is the maximum number of entries in the filter log expressed as a decimal integer.
Values 1 to 50000
syslog-id — specifies that the destination of the filter log ID is a syslog server. The syslog-id
parameter is the identifier of the syslog server.
Values 1 to 10
summary
Syntax summary
Context config>filter>log
Description This command enables the context to configure log summarization. These settings apply only if syslog
is the log destination.
summary-crit
Syntax summary-crit dst-addr
summary-crit src-addr
no summary-crit
Context config>filter>log>summary
Description This command defines the key of the index of the mini-table. If key information is changed while
summary is in the no-shutdown state, the filter summary mini-table is flushed and reconfigured with
different key information. Log packets received during the reconfiguration time will be handled as if
summary was not active.
The no form of the command reverts to the default parameter.
Default dst-addr
Parameters dst-addr — specifies that received log packets are summarized based on the destination IP
address
src-addr — specifies that received log packets are summarized based on the source IP address
To Next Page
Loading...
