Filter Policies
7705 SAR OS Router Configuration Guide 347
The no form of the command removes the match criteria for the entry-id.
Parameters next-header — the IPv6 next header to match. This parameter is similar to the protocol parameter
used in IPv4 filter match criteria.
Values [1 to 42 | 45 to 49 | 52 to 59 | 61 to 255] — (values can be expressed
in decimal, hexadecimal, or binary – DHB)
keywords: none, crtp, crudp, egp, eigrp, encap, ether-ip, gre, icmp,
idrp, igmp, igp, ip, ipv6, ipv6-icmp, ipv6-no-nxt, isis, iso-ip, l2tp,
ospf-igp, pim, pnni, ptp, rdp, rsvp, stp, tcp, udp, vrrp
* — udp/tcp wildcard
match
Syntax match frame-type {802dot3 | 802dot2-llc | 802dot2-snap | ethernet_II}
no match
Context config>filter>mac-filter>entry
Description This command creates the context for entering/editing match criteria for the filter entry and specifies
an Ethernet frame type for the entry. When the match criteria have been satisfied, the action associated
with the match criteria is executed.
If more than one match criterion (within one match statement) is configured, then all criteria must be
satisfied (AND function) before the action associated with the match will be executed.
A match context may consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
The no form of the command removes the match criteria for the entry-id.
Default frame-type 802dot3
Parameters frame-type — configures an Ethernet frame type to be used for the MAC filter match criteria
802dot3 — specifies the frame type as Ethernet IEEE 802.3
802dot2-llc — specifies the frame type as Ethernet IEEE 802.2 LLC
802dot2-snap — specifies the frame type as Ethernet IEEE 802.2 SNAP
ethernet_II — specifies the frame type as Ethernet Type II
To Next Page
Loading...
