Route Policy Command Reference
470 7705 SAR OS Router Configuration Guide
Parameters name — the prefix list name. Allowed values are any string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces, etc.),
the entire string must be enclosed within double quotes.
protocol
Syntax protocol protocol [all | {instance instance}]
no protocol
Context config>router>policy-options>policy-statement>entry>from
config>router>policy-options>policy-statement>entry>to
Description This command configures a routing protocol as a match criterion for a route policy statement entry.
This command is used for both import and export policies depending on how it is used.
If no protocol criterion is specified, any protocol is considered a match.
The no form of the command removes all instances of the protocol from the match criterion.
Default no protocol
Parameters protocol — the protocol name to match
Values aggregate, bgp, bgp-vpn, direct, igmp, isis, ldp, mld, ospf, ospf3,
pim, rip, static
all — specifies that all instances of the protocol are used as match criteria (only applies to IS-IS)
instance — the instance ID of the specified protocol (only applies to IS-IS). If no instance is
specified, instance 0 is used.
Values 1 to 31
source-address
Syntax source-address ip-address
no source-address
Context config>router>policy-options>policy-statement>entry>from
Description This command specifies the source address that is embedded in the join or prune packet as a filter
criterion.
The no form of the command removes the criterion from the configuration.
Default n/a
Parameters ip-address — the IP prefix for the IP match criterion in dotted-decimal notation
To Next Page
Loading...
