Programming your telephone
8AL91432ENAD ed01.1 70/94
3.22.2 First connection as remote working
When you connect your desk phone for the first time remotely, you are prompted to set a PIN code.
The PIN code is requested when you enter in the VPN configuration (submenus) or when you boot
your desk phone (depending on the VPN configuration).
The PIN code is retained during the session so that you can access the VPN configuration without
having to re-enter your PIN code until you exit the VPN configuration.
Before configuring your phone for remote working, check if you have all the information from your
administrator.
If your set is not equipped with a magnetic keyboard, use the alphanumeric keyboard to enter
letters. Use the alphanumeric keyboard key to switch between the numeric and alphabetic keyboard.
When in alphabetic mode, the LED corresponding to the key remains lit up.
To configure your desk phone:
• Access to the administration menu of the desk phone (see chapter above).
• Remote Config
• VPN (scroll down the menu).
o Enter the new PIN Code.
o Validate (the desk phone reboots when you activate the PIN code).
• VPN Config
o Enable VPN: you have to activate this option to use your desk phone for remote
working.
o VPN Server: enter the address of the VPN server.
o Validate.
o VPN PSK: enter the pre-shared key to establish a secure connection with the VPN server.
The PSK can be unique for all remote workers on a same installation or can be specific
to each remote worker. In the first case, the VPN authentication has to be enabled.
o IKE version: Enter the IKV version (IKEv1/IKEv2).
o Other advanced settings if requested: IKEv1 aggressive mode (when IKEv1 enabled), IKE
force encapsulation, Static Virtual IP (VIP Addr).
o Validate.
• VPN Servers
o Force config: force using the selected configuration.
o TFTP: tftp #1, tftp #2,port: if TFTP servers are required, activate this option and enter the
addresses and port of the TFTP servers.
• Validate.
• VPN Authent
→
Use Authentification, User, Password: activate this option if a logon to the VPN
server (username and password) is required. The VPN authentication can be disabled in case
a specific PSK is used for each remote worker.
Validate.
To Next Page
Loading...
