Configuration Menu
Display Mes-
sage Default Information Limits
Load Param… Are
You Sure ?
No
NOTE: Loading parameters is only required after installing a
new inverter.
Load the inverter Parameters.
• Door must be closed.
• Check if the SETUP is correct.
• Parameter List Version
• Machine type, inverter type, softw version
• Confirm that you want to load the inverter Parameters.
• Check status screen while parameters are loaded.
• Sending Param.: 0 - 100 %
• Verify Param: 0 - 100 %
No / Yes
Total Number of In-
lets
2 A washing machine can be delivered with 2 or 3 main water Inlet sup-
plies.
A machine with 2 main water inlet supplies is prepared for:
• soft warm water
• soft cold water
A machine with 3 main water inlet supplies is prepared for:
• soft warm water
• soft cold water
• hard or recycled cold water
Depending on this selection other inlet valves will be suggested at the
final rinse sequence.
Depending on this selection other inlet valves will be programmed
when the standard programs are loaded.
2 / 3
HopperLess Ma-
chine
No Water inlets in a hopperless washer system are redirected according to
this formula:
3 water inlets machines:
I5 = I5 OR I6 OR I8
I4 = I4 OR I7
I1 = I1 OR I2 OR I3
2 water inlets machines:
I5 = I5 OR I6 OR I8
I1 = I1 OR I2 OR I3 OR I4
FX65 / 80 / 105 /
135 / 180 / 240
only
Drain Val.1 Invert-
ed
No If a drain valve 1 with inverted function (normally closed) or a pump is
used on the machine, then this item must be set to “Yes”.
No / Yes
Table 9 continues...
Initializing the Machine
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
34 Part No. D1676ENR11
To Next Page
Loading...
