Configuration Menu
Display Mes-
sage Default Information Limits
Drain Valve 2 No Some machines with water recovery are equipped with a second drain
valve. If this second drain valve is a normal Closed drain Valve, then
drain valve 2 must be Selected Yes.
No / Yes
Liquid Soap Supply No Some washing machines function with external Liquid soap supplies
and others do not. To program External Liquid soap supplies at the Pro-
gram Menu, this selection must be Yes.
No / Yes
Min. Level Start
Sup.
5 units Soap Supply signals are only started when the pre-set "Minimum water
level Start Supply" has been reached. Refer to Table 6 , minimum pro-
grammable levels.
NOTE: Setting a low or even 0 level increases the risk of
chemical corrosion of the drain valve and the hose between
the tub and drain valve as undiluted detergents will get in
contact with these parts.
0 - Minimum
progr. level
Temperature Select Celsius or Fahrenheit, depending if you prefer that the tempera-
ture is displayed in degrees Celsius or degrees Fahrenheit.
Fahrenheit [Cel-
sius]
Full Heating 1 % This function allows to reduce the energy consumption at long hot
washes.
When the heating has reached the programmed target temperature,
heating will be restarted when the bath temperature goes below the
temperature hysteresis.
• Full Heating 100 %, the heating will be restarted until the end of the
hot wash sequence.
• Full Heating 1 %, the heating will not be restarted once the target
temperature has been reached.
• Full Heating 67 %, the heating will be switched Off 1/3 before the
end of the hot wash sequence.
NOTE: In case of a hygienic program, 100% must be select-
ed.
1 - 100 %
Wet Cleaning No Selection Wet Cleaning allows to program water levels below the
standard minimum programmable levels. The heating will not be
functional for a water level below the standard minimum programma-
ble water level.
No / Yes
Wash programs
Language
Load programs
EU
English
EU
The manufacturer provides standard set of programs (EU) and several
customer sets. To change a set of programs, select a set from a list of
available sets and confirm the selection.
NOTE: After the selection of a different washing machine
has been made, it is advisable to load the standard pro-
grams in the memory. Thus you will make sure, that the ma-
chine is not operated with incorrect water levels or drum ro-
tational speed.
List of available
washing sets
Table 9 continues...
Initializing the Machine
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
35 Part No. D1676ENR11
To Next Page
Loading...
