Configuring Interfaces
Defining MAC Addresses
Page 73
4. Click Apply. The new MAC address is added to the addresses table and the device information is updated.
To delete all MAC addresses:
1. Click Layer 2 > MAC Address. The MAC Address Page opens.
2. Click Delete in the Delete All MAC Addresses section of the MAC Address Page. All addresses are cleared
from the Dynamic MAC Address Table and the device begins to learn new addresses as packets arrive on the
ports.
To view or remove MAC addresses:
1. Click Layer 2 > MAC Address. The MAC Address Page opens.
2. Click View in either View/Add Unicast MAC Addresses section or the View/Add Multicast MAC Addresses
section. The View MAC Address Table Page opens:
Figure 44: View MAC Address Table Page
The View MAC Address Table Page displays all MAC addresses of the selected type (Unicast or Multicast).
3. Click the radio button to select a VLAN ID.
4. Click Remove. The MAC Address is deleted from the list.
5. Click Refresh. The Mac Addresses information is updated.
6. Click Close. The View MAC Address Table Page is displayed.
To Next Page
Loading...
