Allworx
®
Verge™ IP Phone Series User Guide
Page 24 866.ALLWORX * +1 585 421 3850
www.allworx.com
Version: D Revised: June 1, 2017
To create a conference call:
1. Answer or place a call. Press the Conference soft key. If the call is already on hold, it is not
necessary to press the Conference soft key.
2. Do one of the following to place a call:
• dial another extension or external phone number.
•press an available Call Appearance programmable button and then:
• press the Calls soft key and select a call history listing.
• press the Redial programmable button (if available) to call the last number dialed.
•press an available Line Appearance programmable button, and then dial the phone
number.
•press a Contact, BLF, or Redial (if available) programmable button.
• press the Contacts ( ) function button, and then select a contact. If the Personal
Contacts are set to Restricted, Allworx users must enter the assigned credentials, and then
press the Done soft key to access the Personal Contacts.
3. Announce the conference call to the active caller.
4. Press the Merge Calls soft key. The Verge IP phone places both parties into the conference call.
During the active conference call, the originator can press one of the following soft keys:
• Options - select a party and do one of the following:
• place the selected party on hold while the remaining parties continue a discussion. To re-
add the party to the conference call, press the Conference soft key, and then select the
party on hold.
• disconnect the selected party from the call while the remaining parties continue a
discussion.
• Add Call - add a fourth caller to the conference call.
• Leave - exit the conference call while allowing the other callers to continue the conversation.
This feature is only available during a 3-way conference call.
To end the call, do one of the following:
•Hang up.
• Press the Appearance programmable button to remove the caller from the conference call.
• Press the Leave soft key (see above).
• Press the Options soft key (see above).
If the Cell Phone Dialing setting is enabled on the Verge IP phone, using the Call Appearance or Shared
Call Appearance programmable button requires pressing the send ( ) soft key. Cell Phone Dialing is not
available with Line Appearance calls.
To Next Page
Loading...