Allworx Verge IP Phone Series User Guide
866.ALLWORX * +1 585 421 3850 Page 77
www.allworx.com
Version: D Revised: June 1, 2017
5.8 About this Phone
Displays a read-only set of status information regarding the current phone configuration and
information. Users cannot change any of the information.
1. Follow the steps in “To access the setting options:” on page 65 and open About this Phone.
2. Use the up and down navigation buttons to scroll through the available information.
5.9 Admin Soft Key
To configure the Phone Administration options:
1. Follow the steps in “To access the setting options:” on page 65. Press the Admin soft key, and
then enter the Phone Admin Password. Press the Select button.
2. Use the navigation buttons and the Select button to choose the preference setting, and then
choose the preference setting option:
• Network Settings - configure the network settings associated with the phone. Phone
Admins cannot change the setting options with a vertical bar. The table below indicates
the option available for each setting. Press the Archive soft key to save the new settings.
• Factory Reset Phone - Restore the phone factory settings, and then reboot the
telephone to the new settings. Press the appropriate soft key to continue.
When entering an IP Address, use the keypad * button to enter the period between the octet digits.
Network Settings
IP CONFIGURATION
DHCP
• Disabled
• Enabled (default)
SERVICES
Boot Server enter the Boot Server IP number or press the Use Domain soft key
Contact Server enter the Contact Server IP number
SNTP Time Server enter the SNTP Time Server IP number
Auto NAT
• On
• Off (default)
Plug and Play Key enter the Plug and Play Key
To Next Page
Loading...