Amada MU-100A - Precautions for Handling; On Disposal

MU-100A
1. Special Precautions
1-4
(2) Precautions for Handling
 Do not install the Controller in the following locations:
 Damp areas (where the humidity is higher than 90%),
 areas where temperatures are above 40°C or below 5°C
 areas near a high noise source,
 areas where chemicals are handled,
 areas where water may condense,
 dusty areas,
 areas exposed to direct sunlight, and
 areas exposed to large amounts of vibration or shock.
 Before installing the Controller, check the voltage and power supply frequency.
Also, do not place objects around the power supply connector.
 This controller uses the sensor. For stable measurement, turn on the power a
several tens of minutes before using the Controller.
 Clean the exterior of the Controller using a soft, dry cloth or one slightly
dampened with water. If the Controller is very dirty, use diluted neutral
detergent or alcohol. Do not use paint thinner, benzine, etc., as they may
discolor or deform the Controller.
 Do not insert a screw, coin, etc. into the Controller, as they may cause
malfunction.
 Operate the Controller in accordance with the method described in this
operation manual.
 Press switches/buttons carefully by hand. Handling them roughly (using a
screwdriver or the tip of pen) may result in a malfunction or failure.
 Operate the Controller in accordance with the method and connections
described in this operation manual so as not to affect the protective functions.
(3) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time of
disposal, separate it from general industrial waste or domestic waste and carry out
the disposal in accordance with applicable laws and regulations.