Amada MU-100A - Sample Hold 1 Mode Disp Measure Mode: SH1(2)

MU-100A
12. Timing Chart (2-axis Type)
12-9
(3) Sample Hold 1 Mode “Disp Measure Mode : SH1(2)”
When 0=Setup parameter of the function menu is set as follows:
1 Disp Measure Mode setting: SH1(2)
20ms min.
2ms
2ms
18ms
20ms max.
20ms min.
GOOD output(*1)
FINISH output(*1)
NG output(*1)
Before Weld Work measurement position
Before Weld Work measurement
ST-DISP1 input
Displacement change 2
Displacement change 1
ST-DISP2 input
*1 The output time can be selected with Output Select Time.